Bathtub Refinishing Advantages 

When resurfacing a bathtub, there are various variables involved. We’ll walk you through the following easy steps to make your upcoming tub reglazing project a big success. If you are not confident in doing this job by yourself, you can always use a professional Dallas tub reglazing service today. 

Prep your workplace 

You’ll need to carefully prep your workplace before starting your bathtub restoration process. You’ll need to cover all of the nearby surfaces as well as perform all of the appropriate safety procedures. Open a window, turn on the bathroom fan, and use an industrial fan to keep a well-ventilated room and redirect the air outside. 

Caulk should be removed 

Take out the overflow plate from above the tub drain first. Then, remove the caulk where it meets the surround using a utility knife. Ease the caulk off once it starts to loosen with a putty knife ton. 

Thoroughly clean the bathtub 

A tub must be completely cleaned before it can be refinished. Scrub it down with a scouring powder and pad first. You’ll also discover that removing soap scum with a razor scraper works well. Don’t forget about the space beneath the soap dish, where trash is likely to build. Finally, because the drain is the most typical region where tub reglazing fails, pay special attention to it. 

Any damage should be repaired 

The surface of a bathtub that is being refinished must be completely smooth. This necessitates the restoration of any chips, cracks, or other damage. To do so, use masking paper to line the bottom of the tub and a putty knife to apply filler to the imperfections. Before sanding, let the filler dry completely. This procedure must be repeated until the desired result is obtained. 

Sand the Tub 

The tub’s surface must be sanded after it has dried completely. You can sand the surface by hand or with 120-grit sandpaper on an electric orbital sander. You must use your respirator for this stage. Wipe the dust and dirt away with a moist paper towel once you’ve sanded the entire tub. Make sure you wipe away from the drain and toward the tub’s rear. Finally, use lacquer thinner or a detailing compound to finish the job. 

Masking tape should be used. 

After that, you’ll need to tape off the tile around the tub as well as the flooring around it. You should also cover the drain with tape (remove any surplus so it doesn’t get in the way of the glaze). Place a rubber glove or similar barrier over the faucet and showerhead to prevent drips from harming the tub reglazing process. 

Reglaze the tub with a tub reglazing product. 

You’re ready to apply the glaze after you’ve performed steps one through six. Because all bathtub refinishing products are different, be sure you read the instructions properly. The masking can be removed after the tub has dried for a few hours. However, don’t finish this stage too quickly. Otherwise, dust may settle on the tub’s surface and adhere to it. Re-caulk the bathtub after 24 hours. You can finish the project by replacing the overflow cover at the 48-hour mark. 

Leave a Reply

Your email address will not be published.